Technical Notes | DLP & LCD 3D Printing for Jewelry Casting
Field notes from our engineering team on DLP and LCD photopolymer printing for jewelry investment casting. Every note is written for people who run machines, not for people who read brochures.
All technical notes
- Support Strategy for Thin Ring Shanks and Fine Prongs
Why thin ring shanks and prongs bow in DLP printing: support spacing, column stiffness, contact area, and the defect signatures that identify each cause.
2026-11-22 - Layer Thickness vs. Surface Finish in DLP Jewelry Casting: An Engineering Guide
How layer thickness, pixel pitch and exposure dose interact to determine surface finish in DLP wax patterns for jewelry investment casting.
2026-11-21 - Exposure Dose Calibration for Wax-Filled Photopolymer Resins
A measurement-based procedure for finding the exposure window of wax-filled casting resins, including dimensional coupons and post-cure verification.
2026-11-21 - Ash Content and Burnout Behaviour of Casting Resins
Why residual ash matters more than wax percentage, how burnout cycles interact with pattern geometry, and what to measure before changing resin.
2026-11-21
New notes are published regularly. If you want a specific topic covered, send it through the form below.
Ready to discuss your project?
Tell us what you need — our engineering team replies within 24 hours.
Or contact us directly
✉
Email
💬
WhatsApp / WeChat
▶
YouTube
🌐
Website
DLP / LCD 3D printers & casting resins for jewelry and dentistry. Reply within 24 hours.